Maine BMV CDL General Knowledge Practice Test 9
- Questions50
- Correct to pass40
- Passing score80%
- Minimum age16 years
-
1. You are entering a freeway from a short ramp with a fully loaded trailer. What should you do?
Show answer
Answer A: Begin building speed early and wait for a large gap
A loaded vehicle accelerates slowly, so it needs both a running start and a much larger gap than a car would use.
-
2. The coolant temperature gauge climbs above its normal range on a long grade. What is the correct response?
Show answer
Answer C: Stop when it is safe to do so and find the cause before going on
Rising coolant temperature signals a fault such as a lost belt, a leak or a blocked radiator, and continuing can turn a repair into a destroyed engine.
-
3. A tire blows out at highway speed. What should the driver do first?
Show answer
Answer C: Hold the steering wheel firmly, stay off the brake and let the vehicle slow down
Braking while a tire is gone can pull the vehicle out of line, so the driver keeps it straight and lets speed fall before easing off the road.
-
4. What does a front-end header board on a van or flatbed protect against?
Show answer
Answer A: Cargo moving forward toward the cab in a crash or hard stop
The header board, often called a headache rack, blocks forward movement of the load toward the driver.
-
5. Why must the driver of a large vehicle keep it centered in its lane?
Show answer
Answer B: The vehicle needs the full width of the lane
A commercial vehicle is close to lane width already, so any drift takes part of the vehicle into the next lane or onto the shoulder.
-
6. Regular mirror checks during a long trip can reveal which developing problem?
Show answer
Answer D: Smoke coming from a tire or from a wheel
Overheating tires, wheel bearings and brakes usually show as smoke long before anything appears on the dash, and mirrors are where a driver sees it.
-
7. You have countersteered to correct a rear-wheel skid and the vehicle straightens out. What must you be ready for next?
Show answer
Answer D: The vehicle may swing back the other way, so you must steer again to correct it
A vehicle coming out of a skid tends to overshoot and swing in the opposite direction, and the driver must be ready to countersteer a second time.
-
8. Federal rules say a commercial vehicle may not be driven unless what is true of its cargo?
Show answer
Answer B: It is properly distributed and adequately secured
The basic federal requirement is that the load be distributed properly and secured well enough that it cannot move, whatever the paperwork says.
-
9. Using the snub braking method on a downgrade, when does the driver release the brakes?
Show answer
Answer A: After speed has dropped about 5 mph below the safe speed
The driver brakes firmly to about 5 mph under the chosen safe speed, releases to let the brakes cool, then repeats when the safe speed returns.
-
10. Two vehicles of exactly the same length make a right turn, one gently and one very tightly. What is the effect on off-tracking?
Show answer
Answer A: Turning more sharply increases off-tracking, so the tight turn needs more room
Off-tracking depends on both the length of the vehicle and the sharpness of the turn; a tighter corner brings the rear wheels further inside the path of the front wheels.
-
11. How are the headlights, marker lights and turn signals checked during the seven-step inspection?
Show answer
Answer A: The engine is shut off, the parking brake is set, the lights are switched on and then checked from outside the vehicle
The lights are switched on with the vehicle secured, then the driver walks around and confirms each lamp actually works and is clean.
-
12. How does a driver keep a vehicle with a manual transmission from rolling back when starting on an upgrade?
Show answer
Answer D: Partly engage the clutch before the right foot leaves the brake, or hold the vehicle with the parking brake until the engine pulls
Something has to hold the vehicle during the instant the foot moves from the brake to the accelerator, and that is either the clutch at its engagement point or the parking brake.
-
13. You are dropping a loaded trailer in a yard. How far should the landing gear be lowered?
Show answer
Answer A: Until the pads make firm contact and the trailer weight is just off the fifth wheel
Cranking down until the gear is firmly on the ground and just lifting the load off the fifth wheel makes the trailer stable and lets the tractor pull out cleanly.
-
14. What is the payload of a truck?
Show answer
Answer C: The weight of the cargo the vehicle is carrying, that is the loaded weight less the empty weight
Payload is what is left of the legal or rated weight once the weight of the empty vehicle is taken off, and it is the weight of cargo that can be carried.
-
15. When speed doubles, what happens to braking distance?
Show answer
Answer D: It becomes roughly four times as long
Braking distance rises with the square of speed, so twice the speed needs about four times the distance to stop.
-
16. How should the headlamps be checked during the pre-trip inspection?
Show answer
Answer A: By switching on both low beam and high beam and confirming each one works outside
Both beams are separate circuits, so each is switched on in turn and confirmed from outside the vehicle where the lamps can actually be seen.
-
17. You find a defect during the pre-trip inspection. What must happen before the vehicle is driven?
Show answer
Answer C: It must be repaired, or the vehicle must not be driven
Writing a defect down does not make the vehicle safe; a defect that affects safe operation has to be corrected before the trip starts.
-
18. The engine oil pressure gauge falls toward zero while you are driving. What should you do?
Show answer
Answer C: Stop as soon as it is safe to do so and shut the engine down
Loss of oil pressure destroys an engine in a very short time, so the correct response is to stop and shut down rather than to drive on.
-
19. Under the federal hours of service rules, how long may a property-carrying driver drive after 10 consecutive hours off duty?
Show answer
Answer D: Up to 11 hours, and only within a 14 hour window that starts when the driver comes on duty
The federal limit is 11 hours of driving after 10 consecutive hours off duty, and all of that driving has to fall inside a 14 hour window.
-
20. You are about to back across a quiet street into a driveway. Which of these is good practice before you start to move?
Show answer
Answer B: Turn on the four-way flashers and sound the horn to alert anyone nearby
Warning other road users and pedestrians before a reverse maneuver gives them the chance to stop or move clear before the vehicle starts back.
-
21. Why do worn tires lose grip so quickly on a wet road?
Show answer
Answer D: Shallow tread cannot move water out from under the tire
The grooves in a tire exist to channel water away so the rubber can touch the road, and a worn tire has lost that capacity.
-
22. How do you get more engine braking from an automatic transmission on a downgrade?
Show answer
Answer B: Select a lower range before starting down
Locking the transmission into a lower range keeps engine speed high enough to hold the vehicle back and spares the service brakes.
-
23. What combined single limit does Maine require of a vehicle carrying freight for hire wholly within the State?
Show answer
Answer A: 350,000 dollars
Maine sets a 350,000 dollar combined single limit for intrastate commercial freight operations, far above the minimum required of an ordinary private vehicle.
-
24. You are on a freeway and see brake lights come on in several vehicles far ahead of you. What should you do?
Show answer
Answer A: Ease off the accelerator and get ready to slow down
Brake lights well ahead are an early warning that traffic is slowing, and acting on them gives a heavy vehicle the room it needs.
-
25. What is the correct order for a basic double clutch upshift?
Show answer
Answer B: Release the accelerator and push the clutch, shift to neutral, release the clutch, let engine speed drop, push the clutch again and shift to the higher gear
Double clutching passes through neutral with the clutch released so engine speed can drop to match the next gear before it is engaged.
-
26. What is the correct way to make a normal stop?
Show answer
Answer A: Push the brake pedal down gradually and bring the vehicle to a smooth stop
Steady, progressive pedal pressure keeps the vehicle stable and lets the driver behind you react to a predictable slowdown.
-
27. What is the minimum tread depth required in every major groove of a steering axle tire?
Show answer
Answer D: 4/32 inch
Federal rules set a higher tread minimum for front steering tires than for other positions because a steering tire failure is far harder to control.
-
28. During uncoupling, when may the fifth wheel locking lever be released?
Show answer
Answer D: Only after the landing gear is down and taking the weight of the trailer
The landing gear has to be supporting the trailer before the lock is released; otherwise the trailer nose can drop as soon as the tractor pulls out.
-
29. What is the purpose of the torque rods or radius rods you check on the suspension?
Show answer
Answer A: They hold the axle in alignment with the frame under braking and acceleration
Torque rods resist the twisting and fore and aft forces on the axle, so a cracked or missing rod lets the axle move out of alignment.
-
30. You are hauling an open box of loose gravel. What does that load require?
Show answer
Answer A: A cover, so that material cannot blow off or spill onto the road
Loose material that can be blown or spilled has to be covered so it does not come out of the body and strike traffic behind.
-
31. A chain rated at 6,600 pounds is fitted with a hook rated at 4,700 pounds. What is the working load limit of that assembly?
Show answer
Answer A: 4,700 pounds, the rating of the weakest part
An assembly is only as strong as its weakest component, so hooks, binders and links all count and the lowest rating governs.
-
32. How are the extra gears of a multi-speed rear axle or auxiliary transmission usually controlled?
Show answer
Answer D: With a selector knob or switch on the gearshift lever of the main transmission
A range selector on the shift lever lets the driver choose the extra gear range while shifting the main transmission.
-
33. What is generally the safest speed in dense but freely moving highway traffic?
Show answer
Answer D: The speed of the traffic around you, up to the posted limit
Crashes rise with the difference between your speed and the traffic around you, so moving with the flow within the legal limit is safest.
-
34. Federal rules forbid operating a commercial vehicle in which condition?
Show answer
Answer C: In a condition likely to cause a crash or a breakdown
A defect that makes a crash or a breakdown likely has to be corrected before the vehicle is driven, not reported at the end of the trip.
-
35. Why is a leak in the exhaust system especially dangerous in cold weather?
Show answer
Answer A: Carbon monoxide can build up inside a closed cab
In winter the windows are shut and the heater is running, so exhaust gas that escapes early can reach the driver and cause drowsiness or worse.
-
36. May a commercial driver use a hand-held phone while stopped at a red light?
Show answer
Answer B: No, a stop in traffic still counts as driving
Hand-held use is allowed only when the vehicle has been moved to the side of or off the highway and halted where it can safely remain stopped.
-
37. You are pulling a loaded pneumatic dry bulk trailer and approach an exit ramp posted at 35 mph. What is the safest approach?
Show answer
Answer C: Slow to well below the posted speed before the ramp begins
A dry bulk trailer carries its weight high and the load can move, so the ramp speed posted for a car is far too fast and the slowing must be finished before the curve.
-
38. Besides the hours when the law requires them, when should headlights be switched on?
Show answer
Answer A: Any time visibility is poor, such as in rain, fog or at dusk
Headlights are used to be seen as much as to see, so they belong on whenever light or weather makes the vehicle harder to spot.
-
39. An empty van trailer cleared a low overpass on the way in, but on the way back it is loaded. Which statement is true?
Show answer
Answer C: An empty van rides higher than a loaded one, so it needs more clearance than when loaded
Springs compress under load, so an empty trailer is taller; the unloaded trip is the one that can catch a low overhead.
-
40. While you are driving, what should you do to catch a developing problem with the vehicle?
Show answer
Answer A: Check the gauges regularly and pay attention to unusual sounds, smells or vibrations
Inspection continues during the trip: gauges, mirrors and your senses can reveal a problem long before a warning light does.
-
41. A sign before a long descent shows 6 percent. What does that number tell you?
Show answer
Answer A: How steep the grade ahead is
Percent grade is the drop in feet for every hundred feet of road, so the higher the number the faster speed will build and the lower the gear you need.
-
42. Compared with a fully loaded one, an empty truck under hard braking will often do what?
Show answer
Answer A: Need a longer distance to stop because traction is poor
Stiff suspension and little weight over the tires reduce grip, so the wheels lock early and the vehicle can take longer to stop.
-
43. What vision standard must a Maine CDL applicant meet?
Show answer
Answer B: 20/40 acuity with the best eye and a field of vision of at least 110 degrees
Maine screens for 20/40 acuity with the best eye and a total field of vision of at least 110 degrees before issuing a commercial learner's permit.
-
44. You need to pull off onto the shoulder because of a problem with the load. How should you communicate that to other drivers?
Show answer
Answer D: Signal the move, then switch on the four-way flashers once stopped
Other drivers need a signal before you leave the lane and a clear warning once the vehicle is stopped near the traffic lanes.
-
45. Under federal safety rules, what must the driver of a commercial vehicle do before starting a trip?
Show answer
Answer A: Be satisfied that the vehicle is in safe operating condition
The driver is responsible for inspecting the vehicle and must be satisfied it is in safe operating condition before the trip begins.
-
46. The brake pedal goes to the floor in a vehicle with hydraulic brakes. What can you do to build some braking pressure?
Show answer
Answer B: Pump the brake pedal rapidly, which may bring back enough pressure to slow the vehicle
Pumping can restore some hydraulic pressure; along with downshifting and the parking brake it is one of the ways to stop when the pedal fails.
-
47. During the vehicle overview, what should the driver look for on the ground under the vehicle?
Show answer
Answer B: Fresh puddles of oil, coolant, grease or fuel
New stains on the ground are the earliest sign of a leak, so the overview includes a look underneath before anything is opened or started.
-
48. A tire has a cut deep enough to expose the body ply or the belt material. What does that mean?
Show answer
Answer D: The vehicle must not be driven on that tire
Once the structural plies are exposed the casing has lost its strength, and federal rules treat that tire as unfit for the road.
-
49. A strap is a little too long, so a driver ties a knot in it to take up the slack. Is that acceptable?
Show answer
Answer C: No, tiedowns must not contain knots
A knot destroys the rated strength of a tiedown, so the rules do not allow knotted securement devices; the excess is taken up by the winch or ratchet instead.
-
50. Why is a quick lane change particularly risky with a load of hanging meat or of livestock?
Show answer
Answer A: The load swings or leans and can keep pushing the trailer after you straighten out
A swinging or leaning load keeps moving after the vehicle has finished the maneuver, so its momentum acts on the trailer at the worst moment.